This is a working overview of lyophilized powder, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2025-12-05. Anything still debated is marked as such rather than presented as settled.
Melanotan-2 is handled in the laboratory as a lyophilised powder that dissolves readily in water, dimethyl sulfoxide and dimethylformamide, with limited solubility in ethanol. Stock solutions prepared in an organic solvent often precipitate when diluted into aqueous buffer, so gradual dilution with mixing is standard practice. The peptide carries a tryptophan residue and a histidine residue, both sensitive to oxidation and to alkaline conditions. Working solutions are therefore kept near neutral to slightly acidic pH, protected from light, and consumed within the same working session whenever that is practical.
Solid peptide kept dry at minus twenty degrees Celsius, shielded from light and moisture, is generally considered stable for extended periods. Solutions are divided into single-use aliquots and held at minus twenty or minus eighty degrees Celsius, because repeated freeze-thaw cycles promote aggregation and loss of material to container surfaces. Hydrolysis of the backbone and oxidation of tryptophan are the principal degradation routes in aqueous solution, and both accelerate at ambient temperature. Hygroscopic uptake after a vial is opened can also shift the actual mass weighed, which affects any concentration calculated from it.
Routine characterisation relies on reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, using a C18 column and a water-acetonitrile gradient containing trifluoroacetic acid. Electrospray ionisation mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidised by-products that co-elute poorly. Sequence and stereochemistry require additional work, such as peptide mapping or amino acid analysis, because a chromatographic purity figure alone does not distinguish a diastereomer from the target peptide. Independent testing of research-grade material frequently shows measured content below the stated label, so a certificate of analysis is best read together with the method that produced it.
The compound emerged from research programs in the 1980s that examined analogues of alpha-melanocyte-stimulating hormone for pigmentation and photoprotection. Investigators modified the native sequence to extend activity duration and potency. A related analogue, afamelanotide, was developed within the same broad line of inquiry and eventually gained approval in certain jurisdictions for a rare light-sensitivity condition. Melanotan-2 itself did not progress through the same regulatory route and has no approved therapeutic indication.
Melanocortin receptors comprise five subtypes with distinct tissue distributions and functions. Melanotan-2 is described in the literature as a non-selective agonist that engages several of these subtypes, including MC1R, MC3R, MC4R, and MC5R. MC1R is the subtype most directly linked to melanin production in skin cells. Because the compound is not subtype-selective, its observed effects in experimental settings are generally attributed to activity across multiple receptor pathways rather than to a single target.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised material may be hygroscopic |
| Solubility class | Soluble in water, DMSO and DMF | Dilution into aqueous buffer can cause precipitation |
| Storage of solid | Minus 20 degrees C, desiccated, dark | Aliquot to limit repeated opening of the vial |
| Storage of solution | Minus 20 to minus 80 degrees C, aliquoted | Avoid repeated freeze-thaw cycles |
| Identity method | Reversed-phase HPLC with mass spectrometry | Retention time and mass are checked together |
The material is commonly handled as a lyophilized powder in sealed vials. The solid dissolves readily in water and in polar organic solvents, producing a clear solution after reconstitution. Light, heat and repeated freeze-thaw cycles are the concerns most often raised in handling guidance, because peptide bonds and the constrained ring can degrade. Working solutions are generally prepared fresh, and material left in solution is treated as less stable than the dry form. These properties shape how laboratories store and aliquot reference material.
Identity and purity are assessed mainly by reversed-phase high-performance liquid chromatography with ultraviolet detection, often paired with mass spectrometry. Retention time supports identity, while the mass spectrum confirms the molecular weight of the intact peptide. Purity is frequently reported as a percentage of total peak area, a figure that depends on the wavelength, column and gradient used. Impurity profiling may also look for truncated sequences, oxidised forms and residual counterions. Amino acid analysis and peptide mapping provide orthogonal confirmation when required.
Regulatory status varies by jurisdiction, and the substance is frequently described as unapproved for therapeutic use. Some authorities classify it alongside prescription-only medicines or controlled categories, while others address it through general consumer protection rules. Analytical surveys have reported mismatches between label claims and measured content in products sold online, although the scope of such testing is limited. Whether these discrepancies are widespread remains an open question. Discussion in the literature therefore tends to combine chemistry, supply-chain observation and policy analysis.
Melanotan-2 is a synthetic peptide designed as an analog of alpha-melanocyte-stimulating hormone, a signaling molecule produced in the pituitary and skin. Its structure is a linear chain of seven amino acids that folds into a ring through an internal lactam bridge joining two side chains. The compound is sometimes written as MT-II or MEL-2 in informal and commercial contexts. It belongs to the melanocortin peptide family, a group of short signaling molecules that share a conserved core sequence recognized by melanocortin receptors.
Two structural changes distinguish the synthetic peptide from the natural hormone. A norleucine residue replaces methionine at one position, and a D-configured phenylalanine replaces the natural L-form at another. Both substitutions slow enzymatic breakdown, which extends the molecule's persistence relative to the parent hormone. The lactam bridge further constrains the backbone into a stable conformation. These features are standard design strategies in peptide chemistry and are not unique to this compound; they appear across many research peptides built for improved stability.
The compound was developed in the late 1980s and early 1990s by academic researchers investigating melanocortin signaling and pigmentation. Early work explored whether synthetic analogs could reproduce effects of the natural hormone under controlled conditions. The molecule never advanced through the full regulatory pathway required for approval as a medicine. From the mid-2000s onward it appeared in unregulated consumer markets, often distributed through informal channels. That gap between research origins and commercial availability shapes how the compound is discussed today.
Handling guidance for melanotan II follows general practice for small synthetic peptides rather than a product-specific monograph. Lyophilized powder is typically kept at minus twenty degrees Celsius or colder, protected from light and moisture, because warmth and humidity accelerate degradation. Once reconstituted, solutions are usually refrigerated and used within a short window, as hydrolysis and microbial growth both become concerns. Repeated freeze-thaw cycles are generally avoided. These conventions come from laboratory peptide chemistry and not from formal stability studies on this specific compound.
Analytical confirmation of identity relies on mass spectrometry, most often coupled to liquid chromatography. Reversed-phase high-performance liquid chromatography separates the peptide from related impurities and provides a purity estimate based on peak area. Electrospray ionization mass spectrometry then confirms the expected molecular mass, while tandem mass spectrometry can map the fragment sequence. For research-grade material, these two techniques together form the standard minimum. Purity figures reported by vendors are frequently not traceable to an independent laboratory.
== Binding of ligands other than oxygen == Besides the oxygen ligand, which binds to hemoglobin in a cooperative manner, hemoglobin ligands also include competitive inhibitors such as carbon monoxide (CO) and allosteric ligands such as carbon dioxide (CO2) and nitric oxide (NO). The carbon dioxide is bound to amino groups of the globin proteins to form carbaminohemoglobin; this mechanism is thought to account for about 10% of carbon dioxide transport in mammals. Nitric oxide can also be transported by hemoglobin; it is bound to specific thiol groups in the globin protein to form an S-nitrosothiol, which dissociates into free nitric oxide and thiol again, as the hemoglobin releases oxygen from its heme site. This nitric oxide transport to peripheral tissues is hypothesized to assist oxygen transport in tissues, by releasing vasodilatory nitric oxide to tissues in which oxygen levels are low.
== Causes == The cause of JIA remains unknown. However, the disorder is autoimmune — meaning that the body's own immune system starts to attack and destroy cells and tissues (particularly in the joints) for no apparent reason. The immune system is thought to be provoked by changes in the environment, in combination with mutations in many associated genes and/or other causes of differential expression of genes. Experimental studies have shown that certain mutated viruses may be able to trigger JIA. The disease appears to be more common in girls, and is most common in Caucasians. The cause of JIA, as the word "idiopathic" suggests, is unknown and an area of active research. Current understanding of JIA suggests that it arises in a genetically susceptible individual due to environmental factors.
Finally, pressure induced phase transitions where the structure of the crystal is altered during the loading are possible. The response of the MOF is predominantly dependent on the linker species and the inorganic nodes. However, certain MOFs exhibit guest-dependent crystal polymorphism, where different guest molecules can induce distinct crystal phases or configurations. This phenomenon results in MOF crystal structures that change depending on the composition of the surrounding gaseous environment.
While most organisms utilize the ubiquitous NAD+-dependent 2-oxoglutarate dehydrogenase, some bacteria utilize a ferredoxin-dependent 2-oxoglutarate synthase (EC 1.2.7.3). Other organisms, including obligately autotrophic and methanotrophic bacteria and archaea, bypass succinyl-CoA entirely, and convert 2-oxoglutarate to succinate via succinate semialdehyde, using EC 4.1.1.71, 2-oxoglutarate decarboxylase, and EC 1.2.1.79, succinate-semialdehyde dehydrogenase.
Sources: en.wikipedia.org
=== Launch === At 8:04:13 a.m. EST, May 15, 1963, Faith 7 was launched from Launch Complex 14. At T+60 seconds, the Atlas started its pitch program. Shortly afterward, MA-9 passed through max Q. At T+2 minutes 14 seconds Cooper felt BECO (Booster Engine Cutoff) and staging. The two Atlas booster engines had been left behind. The Launch Escape Tower was then jettisoned. At T+3 minutes the cabin pressure sealed at 5.5 psi (38 kPa). Cooper reported, "Faith 7 is all go."
An effective codrug should be pharmacologically inactive in its own right but should release the constituent drugs upon biochemical breakage of the chemical linkage at the target tissue where their therapeutic effects are needed. As such, the chemical linkage (usually a covalent bond) should be subjectable to biodegradation, such as hydrolysis, by an enzymatic or non-enzymatic mechanism. The differential distribution of enzymes capable of catalyzing the breakage of the chemical linkage in different tissues may be exploited to achieve tissue-specific metabolism of the codrug to release the constituent drugs.
The Tissue resource of the Human Protein Atlas focuses on the expression profiles in human tissues of genes both on the mRNA and protein level. The protein expression data from 45 normal human tissue types is derived from antibody-based protein profiling using conventional and multiplex immunohistochemistry. All underlying images of immunohistochemistry stained normal tissues are available together with knowledge-based annotation of protein expression levels. The Brain section provides comprehensive spatial profiling of the brain, including overview of protein expression in the mammalian brain based on integration of data from human, pig and mouse. Transcriptomics data combined with affinity-based protein in situ localization down to single cell detail is available in this brain-centric sub atlas of the Human Protein Atlas. The data presented are for human genes and their one-to-one orthologues in pig and mouse. Gene summary pages provide the hierarchical expression landscape form 13 main regions of the brain to individual nuclei and subfields for every protein coding gene. For selected proteins, high content images are available to explore the cellular and subcellular protein distribution. In addition, the Brain section contains lists of genes with elevated expression in one or a group of regions to help the user identify unique protein expression profiles linked to physiology and function.
Sources: en.wikipedia.org
Purity is normally stated as an area percentage from high-performance liquid chromatography, for example ninety-five or ninety-eight percent. That figure describes the proportion of ultraviolet-absorbing material eluting as the main peak. It says nothing about water content, counterions, residual solvents or mass fraction of the peptide itself.
Peptides are commonly isolated as acetate or trifluoroacetate salts, and the counterion contributes to total mass. Two vials with identical peptide content can therefore differ in weight and in measured response. Residual trifluoroacetate is also relevant in cell-based work because it can influence membrane behaviour.
Degradation products are often closely related to the parent molecule, making them hard to resolve with a single method. Counterion variability adds a further source of scatter between laboratories. Because no pharmacopoeial monograph exists for melanotan-2, groups rely on method-specific validation rather than a shared reference standard.
No. Melanotan-2 is manufactured synthetically. The naturally occurring peptide in the same family is alpha-melanocyte-stimulating hormone, which the body produces as part of normal endocrine and neural signalling.